PRODUCT INFORMATION 

The FlexCard PMC-II is a bus interface device for automotive bus systems in PMC design. The card's 8 bus interfaces can be configured for different bus systems via Physical Layer (FlexTiny II) slots.

 

ADVANTAGE 

> 8x exchangeable bus interfaces, PMC interface (PCI Mezzanine card)

> Physical Layer available for CAN, CAN FD, FlexRay, 100BASE-TX and 100BASE-T1

> Synchronous timestamp generation for all of the 8 bus interfaces (resolution 1 us)

> PMC-Adapter available for: PCI and PCIe

> Driver available for: Windows, Linux and Xenomai

> Numerous triggering options

> Switchable on-board bus termination

> Analysis software included

> 8x exchangeable bus interfaces, PMC interface (PCI Mezzanine card) 

> Synchronous timestamp generation for all 8 bus interfaces (resolution 1 us)

> FlexTiny II exchangeable Physical Layer slots

> 4x Binder 712 8pol connector

> 3,3 V and 5 V compatible PCI power supply, LEDs signal network status

> Trigger- 2x in/out configurable

> Configurable bus termination

> Analyzing software “FlexAlyzerV2” included

> Bosch E-Ray IP Core FlexRay controller

> Bosch D_CAN IP Core CAN controller

> Bosch M_CAN IP Core CAN controller

> MorethanIP 10/100/1000 Mbps Ethernet controller

> V2.1 A FlexRay protocol specification

> V2.0 A/B CAN protocol specification

> ISO 11898-1:2015 CAN protocol specification

> Bosch CAN FD specification 1.0

Installation Windows 

SETP1

Start "FlexCard_Setup_S6V6A-F.msi". Installation details can be found in the enclosed installation instructions. 

SETP2

Update the firmware with the file "FlexCard_PMCII_S6V5-F.fwf" or "FlexCard_PMCII_1FR_4CANFD_S6V5-036.fwf". Also included is an installation instruction.

It is important that you update both parts (Windows driver and firmware) at the same time. The drivers require corresponding licenses, which are noted on the card.

* 하기 링크의 제소사 웹페이지에서 관련 소프트웨어를 다운로드 하실 수 있습니다.

FlexCard PMC-II