It's a specialized solution that helps you better measure automotive functional testing.
Vehicle Ethernet
Network Analysis
Simulation
Functional Test
Engineering Service
Capture both 100BASE-T1 and 1000BASE-T1 without interfering the original network
The Capture Module Ethernet Combo is used to capture the traffic with 2 ports, up-to 1 point-to-point 1000BASE-T1 connection and 4 ports, up-to 2 point-to-point 100BASE-T1 connection. The traffic is captured without causing interference on the network and delivered with a 40 ns resolution hardware time stamp, thus making the analysis of AVB/ TSN traffic possible.
Several devices can be used on the same setup, whenever more 100BASE-T1 ports are needed, and when other IVN technologies are present, the in-built-synchronization using 802.1AS allows for simultaneous use with the other “IVN2Eth Capture Modules”.
Many additional features make this device appropriate for general-purpose testing.
FEATURES
- 1 x Link Lines 1000BASE-T1 (2 Ports)
- 2 x Link Lines 100BASE-T1 (4 Ports)
- Technically Enhanced Capture Module Protocol (time stamping…)
- Configure easily via webserver
- Network Time Synchronization (802.1AS) - allows to synchronize multiple 100 High or any other "Capture Module"
- Cascading and synchronization of multiple devices
- Source Timestamping with 40 ns resolution
- High Speed Startup
- Startup Buffer
- Output Traffic Shaping
- AVB/TSN Capture capable
- Time-Aware Injection
- Rotary Switch for manual configuration of the device´s IP-Addresses (Gbit - RJ-45)
- Wakeup capable
- Extended Power Mode for Car integration
- Robust stainless-steel case
- Size: 137 x 129 x 33 mm.
